What you need to know when installing Fire Rated Downlights

1. What are the requirements regarding downlights in external soffits, are these fixtures required to be fire rated?

If the downlight is installed in an enclosed area, such as a room, the fire is going to increase in temperature and intensity. You won’t see the same temperature or fire intensity outside so the installing of fire rated downlights in soffits is not a requirement.

2. Is there a downlight type that would fit every construction need? For example, no matter what type of joist, no matter if there is insulation or the gap size

Our Edge and Prism Pro can be used in any of the construction types and for the stated durations. I would also state that we have tested our downlight in what is a typical application and spacing, it would be extremely unlikely for more downlights to be used in the field.

Below is a table outlining the certification of Anell’s fire rated downlights.


3. Compliant lighting is one thing, workmanship is another. If the workmanship is poor, would this not compromise the installation?

Absolutely, yes. One of the biggest issues with fire testing is the construction. A lot of the time you can test a floor type or ceiling type with no holes drilled and it could still fail. If the construction workmanship was poor, it is out of the manufacturers and electricians’ control. If you come across something which doesn’t look properly installed, you should note this and highlight to the building inspector.


4. How would I know as a contractor when installing downlights what ceiling joist is used and how do I know the downlight I have is compliant with the ceiling and joist?

A very good question. Firstly how you would know what joist and plasterboard are used would be visually checking where possible, the joist if in a home built 20+ years ago will most likely be Solid Timber, new homes built within this time most likely will be an I Joist, and in more recent years there’s a possibility of Metal Web.

For Plasterboard, you could measure the depth, typically in homes or dwellings you would only see Type A wallboard, it should also be 15mm, if it’s 12.5mm I would look to the date when the house was built to see if it was built in line with the requirements at that time.

For the compliance question, it is the responsibility of the manufacturer to only sell Fire Rated Downlights that have the documentation and certification necessary, I would ask for evidence, that would include a certification number by the test house who carried out the test. I wouldn’t use the downlight if this couldn’t be provided. Or you use a downlight that complies for all like our Edge and Prism Pro then the ceiling type or joist type would not be a concern.


5. Are fire rated downlights required for concrete construction between floors?

When we were conducting our tests, we chose not to go beyond a 60-minute test with metal web joists, as usually in a building concrete would be used within the floors in buildings such as high rise flats. Concrete construction does provide a fire barrier, so fire rated downlights are not required when concrete has been used as separation between floors.

Below is a graphic illustrating the different minimum requirements of fire rated downlights in different types of buildings.